Has a high-capacity filter capacitor and freewheeling diode to protect devices from the reverse current of an inductive load.Able to drive a two-phase stepper motor, four-phase stepper motor or two DC motors.2 enable control terminals to enable or device without inputting signals.Controlled with standard logic level signals.High-Voltage and Current full-bridge driver with 2 H-bridges used to drive inductive loads like DC and Stepper Motors.Continuous working current can reach 2A.Instantaneous peak current can reach 3A.High working voltage – can reach up to 46v.The main features of the L298n Module are: Thus, H-Bridge is basically used to control the rotating direction in DC motors. It has two enable inputs to enable or disable the particular device attached at its output independently.Current control and PWM operable single-chip device are needed.Control unit can only provide TTL outputs.It is needed to operate different loads like motors and solenoid etc where an H-Bridge is required.L298 is a high voltage and high current motor drive chip which receives TTL logic signals.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |